Goldstar R-E21M User Manual download pdf (Page 38)

TROUBLESHOOTING

Your Video Cassette Recorder is a highly sophisticated instrument. It has been carefully checked and adjusted

at the factory under the most rigid quality control and inspection systems. However, should problems develop,

check the following points and take necessary corrective measures.

INSERTING OR REMOVING THE CASSETTE

Symptom

Cassette cannot be inserted

Compartment.

Check Point & Correction

into Cassette

• Load cassette in direction indicated by arrow on

cassette.

• A cassette is already in the VCR.

• Press "POWER" ONIOFF button to "OFF" and

then to "ON" again, and then insert the cassette

again.

RECORDING TV PROGRAM OFF THE AIR

Symptom Check Point & Correction

No picture appears on television screen.

A picture appears on television screen but is not

clear.

The VCR will not go into the recording mode, even

when the "REC/ITR on the VCR or on the remote

control are pressed.

• Press "VCR/TV" selector to turn the "VCR"

indicator on.

• Set the television to the same channel selected on

the RF Channel Select Switch. (Channel 3 or 4).

• Adjust the Tuning Control on television to obtain

best picture.

• The cassette has had the erase prevention tab

removed. Stick a piece of cellophane tape over

erase prevention tab hole or select a different

cassette.

PLAYBACK OF PRE-RECORDED CASSETTE

Symptom

No picture appears on television screen when "PLAY"

button is pressed.

No picture, but audio is clear.

Interference on playback picture.

Picture bends at top of screen.

Color is too bright, too faint or changes.

Check Point & Correction

• Set the television to the VCR channel (3 or 4)

depending upon the selected channel on the RF

Channel Select Switch.

• Try different cassette tape.

• Take VCR to Sears Service Center for service.

• Adjust fine tuning knob on television set to obtain

best picture.

• Adjust "TRACKING" control button (v or A).

• Take VCR to Sears Service Center for service.

• TV receiver is of older type. It needs to be modified

to work properly with VCR.

• Tape is damaged. Try another cassette.

• TV set has VIR circuit. Turn it off during playback.

- 37-

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44

Comments to this Manuals

No comments

Goldstar R-E21M User Manual Page 38

Comments to this Manuals